Manual Reset Canon IX4000 / IX5000

Untuk update tutorial lengkap Manual reset canon iX400 iX5000 Dalam Bahasa Indonesia silahkan download disini


Terjemahkan sendiri ya!!!!!!

To reset counter Canon PIXMA iX4000 or iX5000 you have to enter to service mode.
Procedure to enter to service mode on Canon PIXMA iX4000 or iX5000 is as following :

Connect the Canon PIXMA iX5000 or iX4000 printer to the power cord. ( note : If the
automatic power-on function is enabled in the printer, the printer enters the service
mode for the first time, but it will never enter the service mode if the printer is
turned off by the Power button. This is because the printer remains to be turned on
internally if the power is turned off by the Power button. To prevent this,
disconnection of the power cord is required before starting the printer in the service
mode ) .

With the Canon PIXMA iX5000 or iX4000 printer powered off, while pressing the Resume/
Cancel button, press and hold the Power button. (note : Don’t release the buttons.
The Power LED lights in green to indicate that a function is selectable.)

While holding the Power button, release Resume/Cancel button. (Don’t release the Power
button.)

While holding the Power button, press Resume/Cancel button 2 times, and then release
both the Power and Resume/Cancel buttons.

When the Power LED lights in green, press the Resume/Cancel button 4 times to reset
waste ink counter in the Canon Pixma iX5000 / iX4000. (note : If the Power LED does
not light in green the printer does not enter the service mode, disconnect the power
cord and plug it again. Then start from step 1 to start the printer in the service
mode again).

At the end of the service mode, press the Power button. The paper lifting plate of
the sheet feed unit will be raised.
Note :

Each time the Resume/Cancel button is pressed, the Alarm and Power LEDs light
alternately, Alarm in orange and Power in green, starting with Alarm LED.
Other specified number of time(s) according to the function listed in the table below.

Time(s) LED indication Function Remarks
0 times Green (Power) Power off
1 time Orange (Alarm) Service test print
2 times Green (Power) EEPROM information print
3 times Orange (Alarm) EEPROM initialization
4 times Green (Power) Waste ink counter resetting
5 times Orange (Alarm) Destination settings
6 times Green (Power) Print head deep cleaning (Cleaning of both black and color)